How To Paste A Membrane Switch Panel

Film switch is a combination of multiple key functions, in the need to install it, we should be the film switch needto fit the surface to clean up, because after the film switch needs to tear open centrifugal paper, if the fit surface is clean, the film switch can fit normally.

Generally as long as the film switch paste went on after the normal use, but everyone in the installation must not repeatedly paste, must be done at once, and tear it angle can not exceed 15 degrees, otherwise it will affect the use of the film switch later feel, After the installation is completed need to try to press the feel, we must put the film switch flat on the desktop and then press, if the table is not smooth, it will affect the life of the film switch.